PLANTISOTBDRAWAREA

Designates draw and no-draw areas in an Iso drawing.

Access Methods

 Ribbon: Project SetupIsometric DWG SettingsTitle Block Setup Isometric Drawing Area

 Command entry:  plantisotbdrawarea

Summary

In Title Block Setup you can create and modify areas for Iso drawings. A draw area specifies the limit area that Iso objects are created in. No-draw areas can be placed within the draw area to specify that Iso objects should not be created within the no-draw area.

A table area is created automatically when you create your first table. You can stretch the draw area.

You can create one draw area. You can create one or more no-draw areas.

List of Prompts

If a draw area does not exist in the table editor, you are prompted to create one.

Specify first corner point: Specify the first corner of a draw area.

Specify other corner point: Specify the second corner of a draw area.

Replace draw area or [Replace draw area/add No-draw area/toggle Visibility]:

Area

Replace Draw Area

Specifies the area to create objects in the isometric drawing.

Add No-draw Area

Specifies areas to exclude objects from in the isometric drawing.

Toggle Visibility

Displays draw-area as a perimeter instead of draw and no-draw rectangles. Draw areas can be selected only when rectangles are displayed.

Visibility

Toggle Visibility

Draw area visibility on.

Draw area visibility off.

Displays draw-area as a perimeter instead of draw and no-draw rectangles. Draw areas can be selected only when rectangles are displayed.