The Reinforcement Pattern dialog allows you to define the parameters of reinforcing bars used during the RC wall design.
Access
Select RC Design 
Provided reinforcement layout, and then create a new RC element or open an existing one.
- Click Analysis Reinforcement Pattern.
- Click
(Reinforcement Pattern).
Dialog elements
The content of the Reinforcement Pattern dialog depends on the RC code selected during the wall design.
Note: Main reinforcement (vertical and horizontal) is generated if the load capacity of an unreinforced wall is insufficient to carry the stresses acting in the wall. If that is not the case, only the anti-shrinkage and constructional reinforcements and, if necessary, the opening reinforcement is generated.
Refer to the topics below to learn about parameters that you can define in the following tabs.