To Create a Corridor Points Report

Create a report that lists specified corridor point code properties, such as chainage and offset, relative to a specified alignment.

1. In the Toolspace, on the Toolbox tab, expand Miscellaneous Utilities Reports Corridor. Double-click Corridor Points Report.
2. In the Create Report - Corridor Points dialog box, under Corridor Selection, select the corridor for which you want to generate a report.
   Note: Click Select Corridor to pick the corridor from the drawing.
3. Under Chainage Range, specify the following parameters:
   • Corridor Alignment Association: Baseline alignment on which to base the report.
   • Start Chainage: Chainage on the baseline at which the report begins. Click to click the chainage in the drawing.
   • End Chainage: Chainage on the baseline at which the report ends. Click to click the chainage in the drawing.
   Note: The Start Chainage and End Chainage values are chainages on the alignment specified in the Corridor Alignment Association.
4. Under Point Code Selection, select the corridor point codes to include in the report.
5. Under Report Alignment Association, specify the alignment to which the reported geometry data is relative.
6. Under Report Settings, use the table to specify the properties to include in the report, as well as the order in which the properties are presented:
   • Arrow Buttons: Move the currently selected row up or down in the table.
   • Include: Includes a property in the report when the check box is selected. To remove a property from the report, clear the check box.
   • Property: Identifies the property name.
   • Column Name: Specifies the user-defined column name for the property in the report.
7. Under Save Report To, click to browse to the location to which you want to save the report, enter a file name, and select a file format.
8. Click Create Report.

   The report is displayed, and is saved to the specified location.

9. If you want to generate another report, you may modify the report parameters and click Create Report again.
10. Click Done to close the dialog box and save the current report parameters for a future session.