Associated Longitudinal Section Page (Create Profile View Wizard)

Use this page to specify the settings for associated longitudinal section views.

Note: This page is not available if the Show Offset Profiles By Stacking Views check box on the General page is cleared.

Number of Stacked Views

Specifies the total number of profile views to create. This unitless value can be any integer from 2 to 9. The graphic on the right-hand side of the page changes to reflect the number selected.

Gap Between Views

Specifies the amount of spacing (in plotted units) to leave between associated longitudinal section views. A negative value in this field causes the associated longitudinal section views to overlap.

Top View Style

Specifies the profile view style to use for the top-most profile view.

Middle View Style

Specifies the profile view style of all profile views between the top-most and bottom-most profile views.

Bottom View Style

Specifies the profile view style to use for the bottom-most profile view.

Preview (unlabled)

Displays the number of profile views specified in the Number of Stacked Views field.