Section View Tables Page (Create Section View Wizard)

Use this page to set volume table properties for the section view.

Note: This page is not available if there is no material list for the drawing. For information about how to create a material list, see Generating Material Lists.

Use the following controls to specify the volume table types to draw:

Type

Specifies the type of the volume table(s).

Select Table Style

Specifies the style of the volume table. Standard buttons are also provided to create or edit a label style.

Add >>

Adds a volume table to the list.

List Of Volume Tables

Table Type

Displays the table type.

Style

Specifies the name of the table style that was added using the Select Table Style list. To change the style, click in this column to open the Select Style dialog box. Select a band style in the list or use the standard controls to either create a new style, copy or edit the style selection, or pick a style from the drawing.

Material List

Specifies the material list for the volume table.

Materials

Click to specify the materials for the volume table.

Layer

Specifies the drawing layer that contains the sampled source.

Split

Specifies whether the layer is split.

Gap

Specifies the distance in plotted units between the data box and the previous data box (or the nearest section view axis). Enter a positive gap value in plotted units.

Reactivity Mode

Specifies the type of update mode for the section. Select Dynamic to specify that the cross section updates dynamically when either the position of the sample line associated with the section changes or the data source (surface, corridor, or pipe) geometry changes.

Position of Table(s) Relative to Section View

Section View Anchor

Specifies the section view anchor (Top/Middle/Bottom, Left/Center/Right).

Table Anchor

Specifies the location of the table anchor (Top/Middle/Bottom, Left/Center/Right).

Table Layout

Specifies whether the layout of the tables will be horizontal or vertical, in relation to the section view.

X Offset

Specifies the distance in plotted units to move the title away from the position set by the table anchor. Enter a positive number to move the title right, or a negative number to move it left.

Y Offset

Specifies the distance in plotted units to move the title away from the position set by the table anchor. Enter a positive number to move the title up, or a negative number to move it down.