Autodesk 360 > Simulation Sync

To manually sync data to Autodesk 360, use the commands in the Autodesk 360 > File panel. To automatically sync to Autodesk 360, however, use Simulation Sync Settings.

To automatically sync your simulation data to Autodesk 360, click Simulation Sync Settings, and check Simulation Sync

• To change the location of file storage within your Autodesk 360 account, specify a different A360 Path location.
• Autodesk 360 syncs the Summary and Status files generated at the conclusion of the simulation. These files contain information about the model, results, and the calculation. For more about these files, click here.
• Autodesk® CFD captures and syncs the model view at the conclusion of the simulation if you select Static image or Dynamic image. This is convenient for examining results remotely: after you start the simulation, define the view of interest using the Results tools. Later, when the simulation completes, Autodesk® CFD captures and syncs an image using your view. You can then view this image and check your results from any Internet-enabled device, even if you are not near simulation computer.
• If you select Support share file, Autodesk® CFD saves and syncs the Support file version of the share. This is the smallest type of share file, and contains the simulation settings, but not the mesh or results. To sync a complete share file, click File > Save Share File from the Autodesk 360 tab.

Autodesk® CFD syncs the selected files at the end of each simulation. If you continue a simulation or run it multiple times, the data is synced each time the simulation finishes. Instead of overwriting data from the previous simulations, Autodesk 360 creates a unique version for each execution. This provides access to all of your simulation data, and does not count against your Autodesk 360 data quota.

For more about using Autodesk 360, click here.