Revolve reference (Surface)
The surface Revolve tool creates a surface body by revolving a selected profile or model geometry around an axis in Fusion.
Design > Surface > Create > Revolve
Profile
Select coplanar sketch profiles or faces to revolve.
Axis
Select a linear or circular object to define the axis to revolve the profile around.
Project Axis
Projects the axis to the same sketch plane as the selected profile. Uncheck to keep the axis in its original location.
|
|
|
|
Left: Check Project Axis |
Right: Uncheck Project Axis |
Extent Type
Establishes the end point of the revolve.
- Partial: Revolves the profile around the axis to an angle value that you specify.
- To Object: Revolves to a body, face, or plane that you select.
- Full: Revolves the profile 360 degrees around the axis.
Angle
Specifies the angle to revolve around the axis.
- If the Extent Type is set to Partial , specify the angle value to revolve the profile around the axis.
- If the Extent Type is set to To Object , select body, face, plane, or vertex to revolve to.
Direction
Controls the direction of the revolve from the profile plane.
- One Side: Revolves profile on one side of the profile plane.
- Two Sides: Revolves profile on each side of the profile plane.
- Symmetric: Revolves profile symmetrically on each side of the profile plane.
Operation
Select an operation to control how the feature affects the design.
- New Body Creates a new body in the active component.
- New Component Creates a new body in a new component.