Learn to use the Revolve tool in Fusion to create a T-Spline body by revolving sketch or model geometry around an axis.

Design > Form > Create > Revolve

Profile

Enables the selection of sketch profiles.

Profile Chain Selection

Specifies whether to include tangentially connected edges or select individual edges for open profiles.

Axis

Select a linear or circular object to define the axis to revolve the profile around.

Weld

Check to weld all coincident vertices. In this example, the four vertices at the top are welded into a single vertex.

Spacing

Specifies how the faces are positioned on the revolution.

• Uniform: Spaces faces evenly around the profile.
• Curvature: Spaces faces based on the curvature of the profile. Higher curvature areas receive more faces.

Faces

Specifies the number of faces along the side of the revolution.

Type

Select an extent Type to determine the end point of the revolve.

• Angle: Revolves the profile around the axis to an angle value that you specify.
• Full: Revolves the profile 360 degrees around the axis.

Angle

Available when Type is set to Angle. Specifies the angle of revolution around the axis.

Direction

Available when Type is set to Angle .

• One Side: Revolves the profile in one direction.
• Two Side: Specify two angles to revolve in each direction.
• Symmetric: Specify a single angle to revolve in each direction.

Faces

Specifies the number of faces around the revolution.

Symmetry

• None
• Circular: Select to embed symmetry in the revolution.

Symmetric Faces

Available when Symmetry is set to Circular . Specifies the number of symmetric faces around the axis of the revolve.