Share
 
 

Wire Numbers Tutorial

Insert wire numbers and signal arrows.

Time required

45 minutes

Prerequisites:

Copy all files located in

 

Users\{username}\Documents\Acade {version}\Aedata\Tutorial\Aegs\Wire numbers

to

Users\{username}\Documents\Acade {version}\Aedata\Proj\Aegs

 
Note: Delete existing files in the destination folder before copying.

Follow the workflow topics listed below to accomplish these tasks:

  • Insert wire numbers
  • Insert I/O based wire numbers
  • Delete wire numbers
  • Understand signal arrows
  • Insert a source arrow
  • Insert a destination arrow

Workflow Topics

  1. About wire numbers
    Understand wire numbers.
  2. Inserting wire numbers
    Use the Wire Numbers command to add wire numbers on individual wires, drawing-wide, and project-wide.
  3. Inserting I/O based wire numbers
    Insert wire numbers based on the I/O address that each PLC connected wire touches.
  4. Deleting a wire number
    Use the Delete Wire Numbers tool to remove unwanted wire numbers.
  5. Source signal arrows
    Insert a source arrow on a wire that breaks and continues in a new location.
  6. Destination signal arrows
    Attach a destination signal to a wire segment of a wire network and relate it to the source signal arrow.

Related Reference

Was this information helpful?