Project-Wide Update or Retag Dialog Box

Resequences or updates component tags, wire numbers, cross references, signal references, select drawing properties, ladders, and title blocks.

Find

Command entry: AEPROJUPDATE

Component Retag

Retag all nonfixed components.

Note: If Ladder References Resequence is selected, the component retag process is performed after the ladder resequencing is complete.

Component Cross-reference Update

Updates the cross-referencing for components on selected drawings.

Note: Cross-references are updated after other options such as component retag or ladder resequencing are performed.

Wire Number and Signal Tag/Retag

Sets options for wire number retagging.

Click Setup to display the Wire Tagging (project-wide) dialog box. Here you can insert or update wire numbers associated with wire line networks across a project

Note: In the Project Properties dialog box (Wire Numbers tab

Wire Annotations), you can enable or disable wire number annotation updates during project-wide or drawing-wide wire number updates for panel footprints and terminal block representations, including graphical terminal strips, tabular terminal strips, and jumper charts.

Ladder References

Renumbers each ladder sequentially.
Resequence Setup	Defines options for starting reference numbers and how to sequence ladders from drawing to drawing.
Renumber Ladders dialog box	Renumbers the ladder for the selected drawings from the active project. Enter the ladder reference number for the first drawing. For all subsequent drawings: Select to use the next sequential reference. Select Skip, drawing to drawing count to enter an amount to skip for the first ladder reference of the next drawing.
Bump Up or Down	Moves ladder references up if drawings were added to the middle of a project or moves ladder references down if drawings were removed from the project. Note: Enter a negative number to move ladder references down.

Sheet (%S value)

Automates resequencing the sheet value on consecutive drawings.
Resequence - Start with	Enter a number to start the resequencing.
Bump-Up/Down by	Select to move the current sheet value up or down by a given count.

Drawing (%D value)

Performs a project-wide update of the %D “DWG NAME” parameter of the drawing.

Other Configuration Settings

Updates the drawing parameters related to component, cross-reference, and wire tagging modes and format project-wide.

Title Block Update

Automates updating title block information for the active drawing or the entire project drawing set.