To Test the Added Circuit

Insert the new circuit.

1. Open a new or existing drawing to insert the circuit. Make sure that the drawing has a vertical 3-phase bus.
2. Click Schematic tabInsert Components panelCircuit Builder drop-downCircuit Builder. Find
3. Look for the new category you added, Custom Circuits, on the Circuit Selection dialog box.

   If it is not there, or is not in the place you wanted, go back to the To Add the Circuit to the Circuit Selection Dialog Box exercise.

4. Expand the Custom Circuits category and select the circuit you added, My 3-ph motor.

   If it is not there or is not in the place you wanted, go back to the To Add the Circuit to the Circuit Selection Dialog Box exercise.

5. Click Configure.
6. Select a location on the 3-phase bus.

   If the wires do not connect to the bus in the way defined, go back to Define Wires Stretching to Connect to Bus exercise.

7. Look through the circuit elements on the Circuit Configuration dialog box. If the circuit element for the new marker block, Extra Component, is not there, go back to Circuit codes sheet.
8. Select Extra Component in Circuit Elements.

   If the options, Red Light, Selector Switch, NO Contact, and None are not displayed in the Select section, go back to Circuit codes sheet.

   If the default value for the Extra Component is not Selector Switch, go back to Circuit codes sheet.

9. Select a component from the list.
10. Select to insert all the circuit elements.
11. If the component selected for the new Extra Component option was not inserted, go back to Circuit codes sheet.
12. If the attribute values for the component are not predefined, LOC=FIELD and DESC1=ADDED COMPONENT, go back to circuit template.
13. If the three terminals are not numbered, T1, T2, and T3, go back to circuit template.