Use this dialog box to specify the parameters for minimizing flat areas on a surface.
Minimize Flat Areas By
- Filling Gaps In Contour Data
-
Specifies that small gaps in contours should be filled in.
- Swapping Edges
-
Specifies that a non-contour common edge shared between a flat triangle and a non-flat triangle should be swapped.
- Adding Points To Flat Triangle Edges
-
Specifies that a new point should be added at the midpoint of an edge shared between a flat triangle and a non-flat triangle.
- Adding Points To Flat Edges
-
Specifies that a new point should be added to edges that bridge two same-elevation data contours and are not in flat triangles.