Share

Fixing connectivity problems in the runner system

  1. Click (Geometry tab > Feed System panel > Move Runners).
  2. Position the cursor over the end of the detached runner, and click and hold the mouse button when the intersection changes to yellow.
  3. Move the runner away from the attachment point and then back again until the intersection point changes to yellow again, and then release the mouse button.
  4. Click (Home tab > Analysis panel > Pre-analysis Check) to perform a runner system pre-analysis check. Once complete, the pre-analysis report either confirms that no errors exist, or highlights the problem areas of the model and displays a message which explains any actions required.
  5. Repeat steps 2 to 4 until no problems are found.
  6. Save the model.
Parent page: Import and Export

Was this information helpful?