Select results to export

Learn how to mark results for export to Autodesk Moldflow Communicator.

You can export results from one or two studies in a single project, which enables your team to view different analyses from a single design iteration, or compare results from two iterations of the design process by using Autodesk Moldflow Communicator.

Note: You can export results from one or two studies. Each study may contain several results folders. You can export a maximum of eight results from each results folder.

In each of the two studies, you must mark each result that you want to export.

Select cellphone_study in the Project View pane.
Right-click on each of the following results, and select Mark for export.
- Fill time
- Pressure at end of fill
- Pressure drop
- Air traps
- Weld lines
- Time to reach ejection temperature
- Volumetric shrinkage at ejection
  
  An asterisk is displayed next to the results in the Study Tasks pane.
Select 2_Inject_loc in the Project View pane.
Mark the same results for export, listed above.

Note: The Analysis Log is marked for export, by default, as indicated by the asterisk. The Analysis Log includes all the information for all analyses that have been run.

Select results to export

Was this information helpful?