Reactive molding analysis sequences
The following analysis sequences are available for the reactive molding process:
This molding process simulation is supported by all mesh types:
Midplane
Dual Domain
3D
| Analysis sequence | Mesh type |
|---|---|
| Fill (Compressible) | |
| Fill + Pack |  |
| Fill + Pack (Compressible) | |
| Flow (Incompressible) | |
| Fill + Pack + Warp (Compressible) | |
| Fill + Pack + Warp | |
| Cool (FEM) | |
| Cool (FEM) + Fill + Pack | |
| Cool (FEM) + Fill + Pack + Warp | |
| Runner Balance (Compressible) | |
| Runner Balance (Incompressible) | |
Note: Flow refers to the analysis sequence, Fill + Pack.
Note: For 3D mesh types, there is no option to select compressible or incompressible, because the analysis run depends on the pvT data entered.
You can also run a Venting analysis ( 3D only) by selecting the option in the Venting analysis tab of the solver parameters dialog, which can be accessed through the Process Settings Wizard.