Share

StairsRun.ExtensionBelowRiserBase Property

Specifies a value to extend/trim the run's first step against base elevation of the stairs if the stairs begins with a riser.


Namespace: Autodesk.Revit.DB.Architecture
Assembly: RevitAPI (in RevitAPI.dll) Version: 26.4.0.0 (26.4.0.0)

Syntax

C#

public double ExtensionBelowRiserBase { get; set; }

Property Value

Double
0.0 if the stairs run connects with stairs landing or the stairs run doesn't begin with a riser.

Exceptions

ExceptionCondition
ArgumentOutOfRangeException When setting this property: The given value for extendBelowRiserBase must be no more than 30000 feet in absolute value. -or- When setting this property: The extendBelowRiserBase is not less than run height. -or- When setting this property: The extendBelowRiserBase is greater than the top elevation of the stairs run.
InvalidOperationException When setting this property: The run cannot extend its below base because its base joins with other stairs components. -or- When setting this property: The run cannot extend its below riser base because it doesn't begin with a riser.

Remarks

This is useful in cases where the run attaches to the face of a floor opening rather than resting on the surface of the floor. Negative value extends the run's first step below the stairs' base elevation. Positive value trims it above the stairs' base elevation. This value should not be greater than run's top elevation.

See Also

Reference

Was this information helpful?