Edit constraints of spliced sets to concrete hosts or other bars.
Spliced rebar sets maintain a connection to each other by using rebar constraints.
When you are editing the constraints of sets in a chain, you are editing the constraints of the entire chain to the concrete host or to other bars.
To edit the end constraint of spliced sets
- Select one of the sets.
- Click Modify | Structural Rebar
Constraints panel
(Edit Constraints)
- Select the end handle you want to edit.
Note: You can switch the splice position for that end by clicking one of the other positions
.
- Click on a concrete face and set an offset for that end
- Editing the constraints of any of the two connected sets has the same effect.
Bar end constraint for a rebar set in splice chain
- edited set in the splice chain.
-
- the current splice position for the bar end handle (middle).
-
- the constraint target for the edited bar end.
-
- the other possible splice positions for the bar end handle (end 1, end 2).
3D View
Bar plane constraint for rebar set in splice chain
- - edited set in the splice chain.
-
- the bar plane handle graphics is shown for the largest diameter bar of all spliced sets.
-
- constraint to the cover.
-
- largest diameter bar of all spliced sets.
