Share
 
 

Model Consistency Check

Run a model consistency check to display and review connection inconsistencies.

To run a model consistency check of your current project:
  1. Click (Check model consistency in the active project) in the bottom right side of the MEP Fabrication Parts palette.
  2. A dialog will display informing you if inconsistencies were found or not.
  3. Click Close or X to exit the dialog.
  4. If the check returns inconsistency notifications, you can review them using the Warnings dialog:
    1. Click Manage tab Inquiry panel (Warnings).
    2. In the Warnings dialog, browse through and select the different warning messages.
    3. Click Show to display the identified inconsistency in the model.
    4. Fix the inconsistencies as needed.
Parent topic: Mechanical, Electrical, and Plumbing (MEP)

Was this information helpful?