The following image shows an example without any extensions: 2D Contour toolpath without any extensions There are three options available for extending the geometry: Create a Sketch Draw a sketch with the geometry extended as needed and select the sketch as the geometry for the 2D Contour.

Click Design > Surface > Modify > Extend . The Extend dialog displays.

Learn how to use the Trim and Extend tools to trim and extend sketch geometry in an active sketch in Fusion.

Click (Design workspace > Surface tab > Modify panel > Extend ) to open the Extend dialog. In the Extend dialog, set the Distance to 20 mm and the Extend Type to Natural.

Click OK. Subspindle extended and chucked.

Learn how to use the Replace Face tool to remove faces from a solid body and then trim or extend the body to new face locations (based on intersecting faces, surface patches, or workplanes).

Select a surface body intersected by an extended surface. Select the section of the extended surface body to remove.

In the Extend dialog, confirm the Extend Type is set to Tangent, and the Distance is 150 mm.

To complete the Trim command, press Enter. Extend border geometry On the toolbar, select Modify > Extend .

Extend sketch geometry On the toolbar, select Modify > Extend .

You can untrim all edges, internal edges, external edges, or manually select the edges you want to untrim. Extend The Extend tool extends a face or surface by selecting one or more edges and moving them away from the face.

Learn how to use the Untrim tool to extends trimmed surfaces and fills gaps, holes, or empty regions of a surface in Fusion.

You pause the cursor over the sketch geometry to preview the segment to be trimmed, then click the segment to trim it. Extend The Extend tool extends sketch geometry to the nearest extended intersection with other geometry in the active sketch.

Learn how to use the Point Through Two Edges tool to create a construction point at the intersection or extended intersection of two edges in Fusion.

Steps Trim away the stem, where it extends into the shovel face. Click (Design workspace > Surface tab > Modify panel > Trim) to open the Trim dialog.