Taper Angle Specify angle to taper extrusion . Wall Thickness (Thin Extrude type only) Specify wall thickness for thin extrusion .

In this activity, you sketch a rectangle and extrude it to envelope the bottle, then cut the bottle from the extrusion to create a body that represents the volume of fluid that the bottle can contain.

You then created a new sketch and extruded a cylinder that cut through the first extrusion .

Specify the Taper Angle to taper the extrusion . For the Thin Extrude type, specify the Wall Thickness.

Enter a positive value to extrude away from the selected geometry or a negative value to cut into it.

Round Cuts : Creates a center mark for round cuts .

Round Cuts : Creates a center line for round cuts .

Round Cuts : Creates a center mark for round cuts .

You then made a cut feature by extruding the circular profile.

Drag the Arrow Manipulator through the model so the cut goes all the way through. Note: Notice that PressPull automatically became an Extrude tool.

Set the operation to Join. Click OK. Extrude cut the annular sketch -20 mm to create the key tops.

Finally, you extruded the circles to cut five identical holes in the bracket.

In the Extrude dialog, change the Operation to Cut Select all of the enclosed sketch areas by clicking inside the closed splines.

Round Cuts : Creates a center mark for round cuts .

Round Cuts : Creates a center mark for round cuts .