Learn how to use the Trim tool to remove unwanted surface area in Fusion.

The Trim dialog appears. In the Trim dialog, select a Trim Type option: Polygon: Lets you place three or more points to create a polygon that covers an area of a toolpath.

You Trim the piece of the shaft that extends into the shovel face Trim the circular piece of the shovel face, where it meets the shaft Trim the front edge of the shovel face to shorten the face and create a flat opening.

Use the Plane Cut tool to trim or split a mesh body with a plane in Fusion.

Learn how to use the Trim and Extend tools to trim and extend sketch geometry in an active sketch in Fusion.

Changing a parameter can require a lot of recalculation time for a large toolpath. A trim modification is quicker and it also gouge-checks any leads or links that are added as a result of the trim .

It then extends or trims adjacent faces of the solid body to the new Target face location.

Click again to create an additional copy. Click OK. Trim border geometry On the toolbar, select Modify > Trim .

You can use the Press Pull tool to modify existing chamfers. Trim The Trim tool splits intersecting surfaces and removes one or more sections of a surface or quilt.

Pull away - The toolpath pulls away from the workpiece to maintain a safe distance between the shaft and/or holder. Trimmed - Sections of the toolpath that result in safe distances between the shaft and/or holder being violated are trimmed away.

In this tutorial, you Setup the project with appropriate units Created complex surfaces from simple sketch lines and curves, and modified their size and shape using the Trim and Extend tools. Rolled back the Timeline to modify the surfaces, and watched the changes propagate through features later in the timeline.

In this tutorial, you Set up the project with appropriate units Create surfaces from sketch lines and curves Trim unwanted surfaces to create the shovel design Create the solid shovel from the surfaces and apply a plastic material.

If the collision cannot be avoided with 4-axis motion, the colliding areas of the toolpath are trimmed away. In the Tool tab, specify Shaft & Holder clearances so that collision avoidance can keep the tool clear from the part by the specified clearances.

Learn how to use the Untrim tool to extends trimmed surfaces and fills gaps, holes, or empty regions of a surface in Fusion.

The two directions are then trimmed so that for any given area, only the directions that are machined across the sloped areas remain.