Run a Fill + Pack analysis

1. Click (Home tab > Molding Process Setup panel > Analysis Wizard).
   
   
2. From the Sequence tab, clear the all analyses, then scroll down and select Fill + Pack from the Select analysis sequence list.
3. Select a material from the Material tab, or leave the default.
4. Select the Process settings tab and make any edits that you would like.
5. Select the Advanced tab and alter the packing profile if you would like.
6. Click Finish to close the Analysis Wizard.
7. Select the Tasks tab in the Study Tasks pane and confirm that all the required steps have been completed and checked off.
8. Click Start Analysis to start the analysis.
9. Click OK when the analysis is complete.