Input Process Parameters

In this task, you use the input the process settings plus, run the analysis.

  1. Click Home > Molding Process Setup > Analysis Wizard.

  2. Uncheck Fill.

  3. Check Cool.

  4. Check Fill+Pack.

  5. Check Warp.

  6. Click Next.

  7. Ensure that the material is Styron EUR, Magnum 3416 SC, then click Next.

  8. Ensure that the mold temperature is 50° C

  9. Ensure that the Melt temperature is 250° C.

  10. Ensure that the injection time is 3.5 seconds.

  11. Ensure that the Mold-open time is 5 seconds, then click Next.

  12. Ensure that the Packing profile control is % end of fill pressure.

  13. Ensure that the profile is 0 - 80, 10 - 80.

  14. Enter 25 seconds as the Injection + Packing + Cooling time.

  15. Click Analyze.

  16. When the analysis is finished, click Summary to close the Summary panel.

Previous ¦ Next