In this tutorial, you:
- Created a project
- Imported a CAD model
- Used Fill Preview to look at the filling pattern with different gate locations
- Meshed the part
- Checked the mesh
- Cleaned the mesh
- Set up and ran the analysis
- Reviewed results
Be Adventurous
The results are less than ideal. Ideally the center two buttons fill at the same time as the outsides. Play around with the study. Some suggestions for playing include:
- Look at to see what you can change for a plot.
- Look at the other results available.
- Save the study with a new name using and run a second analysis with the melt temperature at 250C. Compare the results between the two studies.
Previous ¦ Done