Click Reinforcement pattern on the toolbar or select Analysis > Reinforcement Pattern from the menu to set the parameters of reinforcing bars used during design of an RC wall.
Options provided in this dialog box depend on a selected RC design code. The following tabs are available in the dialog.
General
Distributed reinforcement
Wire fabrics
Opening reinforcement (for the BAEL code)
Edge reinforcement
Shapes.
Note: Main reinforcement (vertical and horizontal) is generated if the load capacity of an unreinforced wall is insufficient to carry the stresses acting in the wall. If that is not the case, only the anti-shrinkage and constructional reinforcements and, if necessary, the opening reinforcement is generated.