To Create Roundabouts

1. Click Home tabCreate Design panelIntersections drop-downCreate Roundabout Find.

   You are prompted to select a roundabout center point.

2. Click on the location where you want to insert the roundabout center point.

   After selecting the center point location, you are prompted to select an approach road.

3. Select the first approach road by clicking on an alignment in the drawing.
   Note: When an alignment is selected, the alignment temporarily displays as a dashed line. If the alignment does not change to a dashed line, is not selected.

   You are prompted to select the next, and successive, approach roads.

4. When you are finished selecting approach roads, press Enter.

   The Create Roundabout - Circulatory Road dialog box is displayed.

5. Select desired options on the Create Roundabout - Circulatory Road dialog box, and then click Next to proceed to the next roundabout dialog box.
6. On the Create Roundabout - Approach Roads dialog box, select the desired options, and then click Next.
7. On the Create Roundabout - Islands dialog box, select the desired options, and then click Next.
8. On the Create Roundabout - Markings and Signs dialog box, select the desired options, and then click Finish.
   Note: Informational messages may be displayed to inform you of certain conditions.

   The roundabout is created in the drawing.