Review and Specify Design Data

Review data on geometry, load cases and combinations, and static analysis results.

Review the following design data:

• Geometry data

  Specify rib and slab settings.

• Load cases and combinations

  Assign load cases from the model to the ANSI/AISC 360-10 load natures.

• Loads. It applies to the Internal Engine method.
• Results of static calculations
• Extreme values of internal forces.

The extension reads geometry data, simple load cases, and results of static calculations from a Robot model. Before you start the design, review this data. If modifications are necessary, close the Rozszerzenie Projekt belki kompozytowej dialog, and modify the data in Robot. Then click Analysis > Calculations to perform static calculations of the model and open Rozszerzenie Projekt belki kompozytowej dialog again.

Units for design data are read from the Robot model. To access unit settings in Robot, click Tools > Job Preferences > Units and Formats.