To Use Slab/Roof Slab Pivot Point Grips

Use this procedure to change the pivot point of a slab or roof slab. (You can also use the Properties palette to change the X, Y, and Z values of the pivot point.)

By default, the pivot point is the first vertex of the baseline. However, you can move the pivot point to any other point, either on or off the slab or roof slab.

Note: If a Hold fascia elevation constraint was set for the object, the pivot point is ignored.

1. Select the slab or roof slab.
2. Select the Pivot Point grip.
3. Move the cursor until the pivot point is in the desired location, and then click.