Click Solve from the Setup tab:

Click the Physics tab.

Flow = On

Compressiblity = Compressible

Total Temp. =162

Total Temp Unit = Celsius

Click the Turbulence button. On the Turbulence dialog, set the Turb. model to SST k-omega, and click OK:

Click the Control tab.

Iterations to run = 1000

Click the Result quantities button.

Enable output of Mach Number by selecting Mach Number. Click OK.

Click the Solution Control button. On the Solution Controls dialog, click Advection.... On the Advection Options dialog, select ADV 5. Close both dialogs.

Click Solve to start the analysis.

The Automatic Convergence Assessment will probably stop the analysis before it reaches 1000 iterations. To run additional iterations, follow these steps to disable Automatic Convergence Assessment:

1. On the Control tab, click the Solution control button on the Solve dialog. 2. On the Solution Controls dialog, click the Advanced button. 3. On the Advanced Solution control dialog, uncheck Automatic convergence assessment. 4. Close both dialogs. 5. On the Solve quick edit, click the Solve button to continue the analysis.

As the mesh is created, informational messages are displayed in the Output Bar.

If this was launched from Pro/Engineer, the CAD interface appears during mesh generation, and status messages are written to the CAD interface.

Back | Next