Create a pressure network from a selected object in the drawing.
This command converts lines, arcs, 2D and 3D polylines, splines, feature lines, alignments, and survey figures into connected pressure pipes and bends.
On the
Home tab, click
Create Design panel
Pipe NetworkCreate Pressure Network From ObjectFind.
Select the object to be converted. Only one object can be selected.
Note: Arcs are converted into curved pipe segments.
Spline segments are converted into straight pipe segments connected with bends. If none of the available bend angles can be used, then the pipes are created without fittings to connect them.
When converting an alignment that contains spirals, the spirals are converted into multiple curved pipe segments.
Accept the current direction or reverse the direction.
size and material for the pressure pipes (parts will share the same material and nominal diameter)
layers
reference surface
whether to create a surface profile for the pressure network to follow
reference alignment
horizontal offset
elevation reference
Select Erase Existing Entity to delete the original object when the pressure network is created.
Click OK.
After the pressure network is created, you can use the
Design Check command to identify pipes that exceed the allowable deflection or minimum flexible radius.
Appurtenances are not added when using this command.