Use this procedure to change the angle of the sides of the building section boundary. You can change the angle dimensions before or after you create a connected section. If you change the angles after creating the section, you need to update the section to show the changes.
- Double-click the section line you want to change.
- On the Properties palette, click the Design tab, expand Basic
Component Dimensions. - Specify values for Angle 1 and Angle 2.
These values define the angles of the two sides from the section line to create the section box. The apex of Angle 1 is the start point of the section line. The apex of Angle 2 is the endpoint of the section line. Values for these angles must be between 0 and 90 degrees.
Specifying section angle parameters
- Right-click, and click Deselect All to turn off grips.