Use the following information to troubleshoot issues when generating a layout for duct or pipe.
Depending on the type of layouts that you create for your system, you may encounter failed layouts. The following table lists reasons for failed layouts and provides solutions.
| Reasons for Failed Layouts | Solution |
|---|---|
| One or more very short layout segments prevent fitting placement. | Modify the problematic layout segments to increase their length. |
| Slight change in offset elevation prevents fitting placement. | Modify the main or branch offset elevation for the layout, and verify the slope setting. |
| Elbow fittings are placed back-to-back to create a flattened “Z” condition. The layout segment between the elbows is either too short preventing fitting placement, or the elbows overlap. | Modify the layout segment to increase the length between the elbows, or modify the main or branch offset elevation in the conversion settings dialog. |
| Tee fittings are placed back-to-back going in opposite directions. | Select a duct type in the conversion settings dialog that uses taps instead of tees. |
| Vertical layout segment connects to a bend, or to a tee or cross fitting, causing a 3-way connection. | Select a different solution to remove the 3-way connection, or modify the duct run after converting the layout. |