Select a zone in the Grading Objects Browser or in the Visualization Display to open this properties panel. Use this dialog to modify the constraints for individual zones. This includes parking lots.

Property Definitions

Name

Specifies the display name of the zone.

Slope Constraints

Select from one of the following slope constraint options for the zone.

Use Global Constraints. Specifies the Global Constraints specified in the Optimization Options dialog should apply to the zone. Click Change Global Settings to open the Optimization Options dialog.

Customize Slope Constraints. Enables slope constraint properties for the zone. When selected, you can edit slope constraint properties for the zone.

• Max Slope. Specifies a maximum slope optimization constraint for the zone.

• Min Drain Slope. Specifies the minimum drainage slope for the zone. For optimization, the zone must have an internal or external drain element or a specified Minimum Drain Inclination.

No Slope Constraints. Disables slope constraints for the zone. The minimum drainage slope is then zero and the maximum slope is infinity. When selected, the slope constraints cannot be edited.

Aligned Surface

Specifies that surface geometry aligns along a flat or asymmetrical plane dependent on the slope and drainage properties of the zone. The direction of this resulting sloped plane is defined by the Inclination Direction property.

Exclusive Drainage

When enabled, the zone will only recognize drain lines and low points within the zone. Drain elements outside the zone do not influence the contents of the zone, however surface triangles outside of the zone are affected by the internal drain elements.

Isolate Internal Drainage

When enabled, drainage objects within the zone will not influence the drainage of other zones.

Minimum Drain Inclination

Specifies that every triangle on the surface has a minimum required inclination into a given angle as defined by the Inclination Direction property.

Inclination Direction

Specifies the direction of the Minimum Drain Inclination. In determining a direction, 0 is east; 90 is north; 180 is west; and 270 is south.

When working in the source drawing, click to use the Inclination Picker tool and click in the intended direction for the Minimum Drain Inclination.

Depth of Material

Represents a depth of materials that should not be considered with the cut and fill data.

Breakline

When enabled, the zone segments work to create a consistent slope along the line.

Grading Limit

Specifies surface triangles along the boundary are fixed to their original elevations so grading does not occur outside of the zone.

Follow Global Objective Weights

Specifies the following global Objective Weights defined in the Optimization Options dialog should apply to the zone. Deselect a constraint to exclude it from optimization.

Balance Cut and Fill. A specified weight with which to minimize the difference between total cut and total fill.

Minimize Earthwork. A specified weight with which to minimize the total amount of earthwork (the sum of total cut and total fill).

Smooth Surface. A specified weight with which to minimize the grade change between adjacent triangles on the surface.

Color

Specifies the color of the representative point, line segments, or areas of the grading object in the visualization display.

Active

Enables the grading object to be included in the optimization. When deselected, it is ignored.

Visible

Enables the grading object to be seen in the visualization display. When deselected, it is hidden but still active.

---