You can zoom to a point name, point number, or a range of point numbers. You can run this command at the command line or as a transparent command from within another command.
If a point is not in the current drawing a message is displayed at the command line. If a point included in a series of points is missing, then it is ignored and the location of all the other points will be used.
To zoom to a point
- On the ribbon, click
COGO Points contextual tab
COGO Point ToolsZoom To Point Find. At the command line, enter the point name or number.
To zoom to a list of points
- At the command line, enter ztp and then enter point numbers separated by commas.
To zoom to a range of points
- At the command line, enter ztp and then enter the range of points separated by a hyphen.
To transparently zoom to a point from within another command
- Click
Transparent tab
Plan panel
Zoom To Point
Find.
- Right-click to display the
Transparent Commands context menu
Zoom To Point.
- Activate the Transparent Commands toolbar and select
Zoom To Point
.
- At the command line, enter
'ztp and then enter a point name, point number, or a range of point numbers.
After you run the command as a transparent command, the command line returns to the main command after a single zoom.
Note: At the command line you can enter a comma delimited list that contains both point numbers and point names.