- Create a traverse, or open an existing traverse.
For more information, see To Open an Existing Traverse.
- In the
Coordinate Geometry Editor dialog box, select the
Scale and Rotate Output check box.
The cells to the right of the check box become available.
- Enter a rotation value in either of two ways:
- Specify a COGO point directions for the baseline (Direction 1) and adjusted (Direction 2) angles. For example, you could enter 1 to 2 as the baseline
Direction 1), and then 2 to 4 (Direction 2) as the new direction. The difference between those two angles is the rotation angle. Click
to specify the directions by picking locations in the drawing.
Note: The difference between the Direction 1 and Direction 2 values is displayed in the Rotation Angle cell. - Enter a known angle in the Rotation Angle cell.
- Specify a COGO point directions for the baseline (Direction 1) and adjusted (Direction 2) angles. For example, you could enter 1 to 2 as the baseline
Direction 1), and then 2 to 4 (Direction 2) as the new direction. The difference between those two angles is the rotation angle. Click
- On the main toolbar, click
.
- Click Close.