Share

Starting ConfigPost from within PartMaker

To start ConfigPost from within PartMaker, select Job Optimizer > Configure Post Processor.

If you choose Configure Post Processor from within:

  • PartMaker/Mill, ConfigPost opens with the Target Application set to PartMaker/Mill.
  • PartMaker/Turn, ConfigPost opens with the Target Application set to PartMaker/Turn.
  • PartMaker/WireEDM, ConfigPost opens with Target Application set to PartMaker/WireEDM.
  • PartMaker/Turn-Mill, ConfigPost opens with the Target Application set to PartMaker/Turn-Mill.
  • PartMaker/SwissCAM, ConfigPost opens with the Target Application set to PartMaker/SwissCAM.
Parent page: Getting Started with ConfigPost

Was this information helpful?