Share

Step Solder Joint Calculator dialog box - Calculation tab

Sets parameters for calculation of a step solder joint.

Access:

Ribbon: Environments tab Convert panel Step Solder Calculator

Type of Strength Calculation

Joint Design

Designs the step depth for the indicated load, dimensions, and joint properties.

Check Calculation

Performs the strength check for the specified load, dimensions, and connection properties.

Load

Specifies the force carried by the joint or for the torque in the stepped joint. The direction of load action is shown in the diagram of the solder joint in the dialog window.

Joint Material and Properties

Select the check box to open the Material Database and select a material. Edit the properties of the material, if needed.

Shear Safety Factor

Specifies the Shear Safety Factor value you enter or select in the dialog box that opens when you click the arrow beside the input field. The recommended range of appropriate coefficients is displayed in the dialog box.

Dimensions

Specifies dimensions of connected materials. The picture of the weld joint contains the most important geometric joint dimensions specified in the Dimensions section. Forces and moments which load the joint and which are entered in the Loads section, are represented in the same way.

Results

Assessments of the joint strength, including the results of the strength check, are presented in the Results section. If input parameters are changed, refresh the values in this section by clicking Calculate (F5 key).

Summary of Messages area

Displays the reports about calculation. To open the Summary of Messages area at the bottom of the tab, double-click the double line at the bottom of tabs or click the chevron.

Toolbar Commands

Parent page: Solder Joint Mechanical Calculators

Was this information helpful?