- Repeat the steps you used to create the Contour Roll feature, using the end face of the edge of the first Contour Roll as the new sketch plane:
- As you did previously, project the outside edges of the sheet metal material, and then add a straight line segment. This straight line segment should be on the side of (and parallel to) the long horizontal projection and offset by 100 mm. For the previous contour roll, the axis of revolution was on the side of the two short horizontal segments. By putting the axis on the opposite side of the profile, the revolution will curve in the opposite direction when you create this contour roll.
- With your sketch completed, create the Contour Roll feature.
Notice that the Rolled Angle value is 30 degrees, the last value you used in this command. It is the value you will use for this second contour roll. Your preview should appear as shown in the following image.
- Click OK to create the second 30-degree contour roll segment and close the dialog box.
As a final modeling step, you will use the same sketch and project edges technique to create a sketch to use for a second contour flange.