Sprue (Procedure)

Modeling the sprue is one of the first steps in defining the feed system.

Topics in this section

Setting default sprue properties
Connecting the sprue direct to the cavity
If you do not require a runner system, and you only want to have your sprue connected directly to your cavity, you can use a simple modeling technique.
Sprue creation-no gates specified
Once a mold has been generated, you should define the sprue location. This is the point where the plastic enters the mold.
Sprue creation-gates specified
Once a mold has been generated, you should define the sprue location. This is the point where the plastic enters the mold.
Changing sprue properties

Parent topic: Sprue