Mesh auto repair

The Auto Repair command is used to launch an automatic search and repair of intersecting and overlapping mesh elements. It will also improve the aspect ratio of any bad elements present on the model.

To achieve a higher success rate of repair, once the first automatic search and repair has completed, run the Auto Repair a second time.

Caution: The Auto Repair command is primarily intended for use on Dual Domain meshes. For Midplane meshes, it may not always produce the desired results-if problems are encountered, you can use the Undo command to restore the original mesh. This command does not perform any checks on 3D (tetrahedral) meshes.