Inserts wire with automatic connection and wire crossing gaps or loops.
Find
Command entry:
AEWIRE
|
Wiretype |
Displays the Set Wire Type dialog box where you set the wire type for new wires. |
|
Show connections |
Shows the wire connection points on a component when the wire is close to the component. The points are shown with temporary graphics. |
|
Start Vertical |
Forces the wire in a vertical direction from the previous selection point. This option is available after selecting the first point for the wire. |
|
Start Horizontal |
Forces the wire in a horizontal direction from the previous selection point. This option is available after selecting the first point for the wire. |
|
Continue |
Inserts the next wire segment at the current cursor location and continues wire insertion. |
|
Collision off |
Temporarily disables or enables the collision checking during wire insertion. This setting is remembered only for the current session. Collision checking is on when AutoCAD Electrical toolset restarts. The setting is saved in the global variable GBL_wd_skip_collision_check. A value of 1 indicates to skip collision checking. A value of nil or 0 means to do collision checking. The default setting is nil. |
Collision checking on
Collision checking off