To Set Cleanup Options (Step 2)

As you clean up a map, you select one or more cleanup actions to perform. Each cleanup action detects a different type of map error, for example, duplicate objects, undershoots, or zero-length objects.

To select cleanup actions and set options

1. On the Select Actions Page, select the cleanup actions to perform by adding them to the Selected Actions list.

   To add a cleanup action to the Selected Actions list, select the action in the Cleanup Actions list, and click Add.

   For best results, run Simplify Objects and Weed Polylines individually. Run other cleanup actions individually or with a minimum of other actions.

2. In the Selected Actions list, specify the order of cleanup actions. The order can affect results. The first action in the list is performed first. To change the order, highlight an action and click the up or down arrow.
3. In the Selected Actions list, select the action for which you want to specify settings.
4. Under Cleanup Parameters, specify the settings to use for the selected action. For more information about each cleanup action, click one of the following links:
   • Delete Duplicates
   • Erase Short Objects
   • Break Crossing Objects
   • Extend Undershoots
   • Apparent Intersection
   • Snap Clustered Nodes
   • Dissolve Pseudo-Nodes
   • Erase Dangling Objects
   • Simplify Objects
   • Zero-Length Objects
   • Weed Polylines
5. To review detected errors before correcting them, under Options, select Interactive. To have AutoCAD Map 3D toolset correct all detected errors without further input from you, select Automatic.
6. Click Next.
7. Continue with Step 3: Specifying How to Convert Objects After Cleanup.