To Transparently Use a Profile Chainage and a Level to Specify a Point Location

You can specify the X and Y coordinates for a point by identifying a chainage along the parent alignment of the profile view.

Specify the alignment chainage and the point level either graphically or numerically.

1. When you are prompted to enter a point in a command, do one of the following:
   • Click Transparent tab Profile panel Station From Plan Find.
   • Right-click to display the Transparent Commands context menu Chainage From Plan.
   • Activate the transparent command toolbar and select Profile Chainage From Plan .
   • Enter 'stae.
2. If the main command is not a profile layout or profile view label command, select a profile view.
3. In plan view, select an alignment.
4. Specify a chainage on the alignment by either entering the chainage value or clicking a point on or near the alignment in plan view.

   A selection marker displays the current location on the alignment.

5. Select the profile view again.
6. Specify a level in the profile view by either entering a level value or clicking a point in the profile view.

   In the profile view, a selection marker displays the current level. The chainage location is held at the chainage you selected.

7. Do one of the following:
   • Enter another chainage and level.
   • Press Esc to end the transparent command.