Use this dialog box to pre-configure options for a command session.
|
Representation tab |
||||
|
Alternate units Displays dimension values in both inches and millimeters. The alternate units appear between square brackets. |
||||
|
Dimension not to scale Underlines the dimension value to indicate that the dimension is not to scale. |
||||
|
Theoretically exact Draws a box around the dimension value to indicate that it is a theoretical exact dimension. |
||||
|
Inspection Dimension Draws a box around the dimension value to indicate that it is an inspection dimension. |
||||
|
Reference dimension Draws a parenthesis around the dimension value to indicate it is a reference dimension. |
||||
|
Inspection values Sets options for inspection dimensions |
||||
|
Shape Controls the shape of the frame around label, dimension value, and inspection rate of the inspection dimension. |
||||
|
Round Creates a frame with semi-circles on the ends and separates the fields in the frame with vertical lines. |
||||
|
Angular Creates a frame with lines that form a 90-degree angle on the ends. Vertical lines separate fields in the frame. |
||||
|
None Draws no frame around the values and does not separate the fields with vertical lines. |
||||
|
Label/Inspection Rate Controls the settings for the inspection dimension. Optionally, shows a label and rate as part of the inspection dimension. You can control the label and rate fields individually, so it is not necessary to show both. |
||||
|
Label Toggles the display of the label field on/off in the inspection dimension. |
||||
|
Label Value Enables you to enter the label used to identify individual inspection dimensions. The label appears in the leftmost section of the inspection dimension when you select the Label check box. |
||||
|
Inspection Rate Toggles the display of the rate field on/off in the inspection dimension. |
||||
|
Inspection Rate Value Enables you to enter the rate used to indicate the frequency with which the part is inspected. The value is expressed as a percentage, the valid range being 0 - 100. The inspection rate appears in the rightmost section of the inspection dimension when you select the Inspection Rate check box. |
||||
|
Fits/Tolerances tab |
||||
|
Show fits/tolerances Enables the ability to specify fits or tolerances for the current dimensioning session. |
||||
|
Type |
||||
|
Fits |
||||
|
Symbol Specifies the fit symbol. Click the |
||||
|
Hole Specifies the symbol to use for the hole tolerance, in a stacked fit representation. Click the This option is visible only for stacked fit representations. |
||||
|
Shaft Specifies the symbol to use for the shaft tolerance, in a stacked fit representation. Click the This option is visible only for stacked fit representations. |
||||
|
Representation Displays the Fits Representation dialog box enabling you to select the fit representation. |
||||
|
Tolerances |
||||
|
Upper deviation Specifies the difference between the nominal dimension value and the maximum limit. |
||||
|
Lower deviation Specifies the difference between the nominal dimension value and the minimum limit. |
||||
|
Methods Displays a dialog box enabling you to select the tolerance method. |
||||
|
Precision |
||||
|
Primary precision Specifies the number of decimals for the primary unit. |
||||
|
Alternate precision Specifies the number of decimals for the alternate unit. |
||||
button to display the Fits dialog box, enabling you to pick the symbol and the deviation from a list.