AMBELL2D (Command)

Performs a spring calculation and inserts a Belleville washer spring in the drawing area.

Find

Summary

When you specify the restrictions, the system performs a calculation and recommends the appropriate springs. You can insert the form at the same time you insert the Belleville washer spring. If required, you can insert a spring without performing any calculations.

In order to make the calculation as simple and as clear as possible, the spring types are inserted using the same methods. You use dialog boxes for the selection, calculation, and insertion process. Use the Select a Belleville Spring dialog box to select the standard, the view and spring type.

List of Prompts

The following prompts are displayed.

Start Point

Specifies one end of the spring.

Direction

Specifies a second point through which the spring extends.

Topical Length

Defines the length of spring as you draw it on the screen. The length must be between the maximal loaded length and the unloaded length. Use the Force option to define the length in terms of the corresponding value of force between the minimum and maximum load.