This command creates a point curve fitted to points you select. The points can be part of previously created point curve and point surface objects, or they can be point sub-objects you created explicitly. They can't be CVs.
-
Select a NURBS object. >
Modify panel > Create Curves rollout > Dependent Curves group box > Curve Fit button
-
Select a NURBS object. > Modify panel > NURBS toolbox > (Create Fit Curve)
Fitting a curve to selected points
Procedures
To create a point curve with Curve Fit:
- In the NURBS toolbox, turn on (Create Fit Curve).
- Click two or more points.
A point curve is created. It runs through the points you select, in the order you select them.
You can press Backspace to undo point selection in reverse order.
- Right-click to end creation.
The NURBS object must contain two or more point sub-objects.
Interface
There are no parameters for a point curve created with Curve Fit.