Share

Creating a runner system using the Runner System Wizard

  1. Click runner system wizard icon (Geometry tab > Create panel > Runner System).
  2. Enter X and Y coordinates, or click Center of Mold to position the sprue.
  3. Choose whether you want to use a hot runner system, and enter a value for the Parting plane Z. Click Next to take you to the next page of the Wizard.
  4. Enter values for the diameter, length and included angle for the Sprue, the Runners and the Drops. Click Next to proceed to the next page.
  5. Lastly, enter values for the start and end diameters, and the length of the Gates.
  6. Click Finish to save and close the dialog
Parent page: Runner System Wizard

Was this information helpful?