Part scale plasticity is enabled without plasticity properties assigned for build plate material ##. Stresses will be qualitative and post EDM displacements will be exaggerated.
When *PPLA part scale plasticity is enabled, this critical warning is generated if the build plate properties are specified using *MATE and *MATI, which do not contain the *PLAS card. Lacking these properties, the build plate will not be able to yield during the post-process plasticity step, which will lead to excessive stresses and distortions.
CLI type support structures have been deprecated due to poor meshing behavior. Consider replacing the CLI support file with a STL support file.
CLI support structures are not recommended for use with Netfabb Simulation.
Powder bed side convection set by *PBCP is used without powder properties being enabled via *+PDR. *PBCP convection values will be ignored.
Powder bed side convection *PBCP requires powder elements to be enabled via +PDR.
Substrate bottom convection set by *PCSB is used with a constantly heated substrate, controlled by *PBSH. *PCSB convection values will be ignored.
Powder bed bottom convection *PCSB will be overridden by using a heated substrate, set by *PBSH.
Substrate side convection set by *PCSS is used with an insulated substrate set by *PBIS. *PCSS convection values will be ignored.
Using an insulated substrate by *PBIS will not apply any substrate side convection set by PBIS.