Click Reinforcement parameters or select Analysis > Reinforcement Pattern to set the parameters of reinforcing bars used to design RC deep beams.
The dialog contains the following tabs.
- What's New
- Release Notes
- Learning Resources
- User's Guide
- User's Guide
- User Interface
- Basic Workflow
- Start a Project
- Preliminary Setup
- Prepare the Model
- Create and Apply Structural Loads
- Prepare the analysis
- Run the analysis
- Structure Analysis - Results
- Steel/Timber Design
- Reinforced Concrete Design
- Required (Theoretical) Reinforcement
- Provided (Real) Reinforcement
- Provided Reinforcement of RC Elements
- Link with the RC Element Design Modules
- Provided Reinforcement – Definition
- RC Elements Design
- RC Beam/Continuous Footing Design
- RC Column Design
- Foundation Design
- Deep Beam Design
- Reinforcement parameters - deep beams
- Diagrams - deep beams
- Loads (deep beam)
- Cross-section (deep beam)
- Cross-section (deep beam) - slab
- Wire fabric
- Wire fabric database
- Generation of zones of additional reinforcement in deep beams
- Principles of deep-beam modeling by means of FEM
- Modeling of membrane support conditions
- Modeling of membrane loads applied at a point of a membrane
- Parameters of the FEM mesh
- RC Walls
- RC structure node - beam/column
- RC Slab Design
- Data table - RC structures
- RC Elements Design
- Provided Reinforcement – Calculations
- Provided Reinforcement – Results
- Code-specific Parameters
- Printouts
- Additional Tools
- Additional Notes
- Robot Structural Analysis Extensions
- Robot Structural Analysis Professional Installation
- Autodesk Installation