About Editing Feature Lines

You can use feature line editing commands with several different object types in addition to feature lines.

Note: You can use the feature line commands to edit survey figures, including control points. You should update the survey database after editing a feature line. If you do not, the next time you recalculate the figure from the database, your edits to the feature lines will be overwritten.

The following table lists which objects are supported for each command.

	Feature Lines	Parcel Lines	Survey Figures	3D Polylines	2D Polylines
Elevation Editor	X	X	X
Quick Elevation Edit	X	X
Edit Elevations	X	X	X	X
Set Grade/Slope Between Points	X	X	X	X
Set Elevation By Reference	X	X	X	X
Insert Elevation Point	X	X	X	X Note: Inserts a PI rather than an elevation point.
Delete Elevation Point	X	X	X
Insert High/Low Elevation Point	X	X	X	X
Raise/Lower	X	X	X	X
Raise/Lower by Reference	X	X	X	X	X
Adjacent Elevations by Reference	X	X	X	X
Grade Extension by Reference	X	X	X	X
Set Elevations From Surface	X	X	X	X
Insert PI	X	X	X	X	X
Delete PI	X	X	X	X	X
Join	X	X	X	X
Reverse	X	X	X	X	X Note: This command also supports AutoCAD lines.
Edit Curve	X	X	X
Fillet	X		X	X
Fit Curve	X	X	X	X	X
Smooth	X		X
Weed	X			X	X
Stepped Offset	X		X	X	X
Apply Feature Line Names	X
Apply Feature Line Styles	X
Break	X
Remove Dynamic Links	X
Trim	X
Adding a Feature Line to Surface as a Breakline	X
Convert 2D to 3D Polyline					X
Convert 3D to 2D Polyline				X
Edit Polyline Elevations					X
Quick Profile	X	X	X	X	X